Ways to move a grand piano

Pianos regularly make movers yearly list of items that are most often damaged. Grand pianos are particularly troublesome. Practicing the following procedures for disassembling, cushioning and filling grand pianos will prevent damage, lower claims cost, and improve consumer fulfillment.

1) At least 3 individuals are needed to handle a child grand piano. If the infant grand piano requires to go up or down stairs or if a full or performance grand piano needs to be transported, a minimum of four individuals are required.

2) Always finish a comprehensive and accurate inventory. It might be more effective or necessary to utilize a visual inventory to sufficiently describe and reveal pre-existing damage.

3) As various parts are dismantled, please location all hardware in an appropriately identified parts bag and then position the parts bag in a "Parts Box".

4) Eliminate the music rack (lyre) from its track by pulling it towards the keyboard. Wrap it in a clean furniture pad.

5) Disconnect the lid by removing the hinge pins. Wrap the lid in a tidy furnishings pad.

6) Get rid of the prop that holds the cover open and cover it in a tidy furnishings pad. The prop has a hinge pin and remains in 2 pieces.

7) Get rid of the pedal assembly and cover it in a tidy furnishings pad. The braces at the rear of the assembly rest in slots at each end. When eliminating the screws, please take care not to drop the braces. In addition, please be particularly careful with the push-rods so that they will not get bent. As you face the piano, number the push-rods from left to right as "1", "2", and "3", by positioning a piece of masking tape with the appropriate number on each rod. Note: If masking tape is unavailable, please usage correctly labeled parts bags for this function. When reassembling at destination, please be sure to put the rods in the correct order so that the pedals will work effectively.

8) Pad the piano by putting a tidy rolled furnishings pad (stretch-wrap the pad to avoid it from unrolling) on the cover of the keyboard to prevent it from tumbling open while you handle the piano. Cover the top of the piano with 2 tidy furniture pads, neatly folded around the keyboard. Usage rubber bands to protect the pads. Note: Please make sure that the surface of the piano is dust-free prior to padding it. Padding a highly sleek surface area that is dusty may trigger fine scratches, especially on a black lacquer finish.

9) Position a piano board and attach the straps so that it is prepared to get the piano. The raised brace on the piano board ought to be at the keyboard end of the piano.

10) Get rid of the left front leg by positioning someone beneath the piano at the left end of the keyboard. The other two people need to support the left front corner. The individual below the piano must turn the retaining block so that the long end points away from the leg. The screws, if there are any, ought to then be eliminated. The "beneath" person must then extricate the piano prior to really eliminating the leg. Make sure to have two individuals raising the corner of the piano while the 3rd individual gets rid of the leg. Note: Please make sure to note which legs were eliminated from which positions given that some pianos have legs that are not interchangeable.

11) Location the piano internet on the piano board by lowering the "leg-less" end onto the board. Please be sure to raise the whole piano slightly while completing this maneuver to avoid unnecessary pressure on the staying, attached legs as the piano ideas. Be sure that the piano is focused comfortably against the brace at the end of the piano board.

12) Remove the two remaining legs and wrap them in clean furnishings pads. These legs are kept in place by a "essential and slot" plan. To remove the leg, slide it inward towards the center of the piano until it comes out of the slot.

13) Secure the piano to the piano board by bringing the ends of the straps together and fastening them. Place folded burlap pads over the furniture pads but under the straps to provide extra defense to the edges of the piano. To avoid the strap near the narrow end of the piano from slipping off, connect the loose ends of the 2 straps together.

14) To move the piano over a flat, level surface, tilt the piano and piano board and place a four-wheel dolly under the center of the piano board.

15) To move the piano up or down stairs, use the piano board as website a skid. After sufficiently padding the stairs for security against home damage, place the keyboard end of the piano towards the bottom of the stairs. Connect a bulge strap to the top end of the piano board to prevent the piano from slipping.

16) To pack the piano, leave it on the piano board and place it in a tier as the first base product with the keyboard dealing with the wall of the preceding tier. The best location to pack the padded lid is read this article between the piano and the preceding tier or between the wall and the piano.

Although grand pianos represent a substantial difficulty, they can be moved without damage by using typical sense and practicing the treatments listed above.

Leave a Reply

Your email address will not be published. Required fields are marked *